Signal generator power cable

http://microfluidics.utoronto.ca/dropbot/media/custom_cable_assemblies/signal_generator_power_cable.jpg

This cable powers the signal generator board from the control board. To build this cable you will need wire cutters, wire strippers, and a Mini-Fit Jr. crimp tool.

Note that pin locations on both cable ends should map one-to-one when looking at both ends from the same direction. See diagram below.

Signal generator power cable assembly

Last modified 18 months ago Last modified on 03/22/16 10:01:37

Attachments (1)

Download all attachments as: .zip